This tutorial is by Hiyoko-chan 


You need help on gradient effects to achieve the most accurate look for your costume? Then maybe this tutorial done by Hiyoko-chan can enlighten you! 


Notes from Hiyoko:

"I detailed this according to dyeing the Rikku scarf.. but for one color dyeing, proceed with steps 1 - 4, but instead of switching out colors, proceed to gradually work your way down the material."


Basically you’ll be following the instructions on the package but I’ve made minor adjustments. 
Use only about 1 or 1.5 gallons of water instead of 3 like the package says. This will give the dye more strength and make it more vibrant UNLESS you have a huge swatch of fabric to dye [i'd estimate 3+ yards, then use 3 gallons BUT with 2 packs of dye]. Just make sure you're using enough water for the fabric to freely move in without crowding excessively.



When doing multiple colors, start with the LIGHTEST color then end with the DARKEST (i.e. Yellow to Red) 


Gradient dyeing is also an eyeballing technique, for the most part, you can gauge the look of the gradient by holding it up and looking to see if there are any harsh transitions. If you DO have a harsh transition in a lighter area, take a separate dyeing bucket and fill it with hot water and a SMALL portion of the solution in your current bucket to dilute it and then proceed to dip-dye repair the harsh area.
Selection of fabrics/materials: 100% cotton, linen, rayon, wool, and silk are suggested for Rit dye. Fabrics that contain at least 60% of these fibers are still dyeable however they will not be as strong. My suggestion is to do the gradient dyeing 2 or 3 times, alot of work i know. So CHOOSE wisely! 
100% polyester or acrylic will NOT dye!! As stated above, BLENDS of these fibers with DYEABLE fibers will give you LIGHT results. Please heed my word on this, i've made this mistake before.
It is EXTREMELY important to PRETREAT and POST-TREAT your fabric. Pretreating your fabric will help remove any prior stains or debris. Post-treating involves THOROUGHLY rinsing out the dye after each color [start from warm water and gradually into cold water]. You MUST MUST MUST MUST *breathes* MUST MUST do this!! Especially if you have gradient involving light and dark colors, any traces of the darker dye will rub off onto the other colors!!! It is also important that once you have done this that you wash your material to help remove any last bit traces. 
Remember: DON'T freak out at first that the color looks tremendously dark as you're dip dyeing. When you post treat and dry it, it'll dry to a lighter tone. If you ARE looking for that strong of a color, concentrate the solution with a higher dye to water ratio but work in smaller parts of predye being added to the bucket.





PRECAUTIONS:

Dyeing works well when you use HOT water, so please be careful when touching your fabric or working with the dye bucket.

 GLOVES! Dye does stain your skin, granted it comes out EVENTUALLY, but i don't ever recommend dyeing without a pair for safetys sake. I usually use a pair of wooden disposable chopsticks to do any sort of agitation to the fabric in the dye bath.

 When REMOVING dye using the Rit Color Remover, i noticed it has a very prevailing odor that can be quite sickening, please exercise precaution!

 Staining - should you accidentally stain ceramic/tile, i noticed bleach works wonders to get it out, however obviously if you stain clothing or carpeting, you got yourself a nice blotch  So wear careless clothing.





DIRECTIONS

1. Boil 1 or 1.5 gallons of water [Does not have to be a rolling boil, just enough so that it is hot]. I usually just fill up a large stove pot with sink water and heat that up.

2. Prepare dye in presolution as directed on package. [I use a water bottle for this – just be sure to keep this separate from your actual dyeing bucket; all you basically do is pour the dye powder into the water bottle and then fill up the bottle with hot water, cap and shake to dissolve the powder, be careful when shaking if you don't tighten it off, you get a few splashes! lol]

3. Add 1 cup of salt and 1 tbsp laundry detergent to bucket.

4. Pour boiled water into bucket. *CAREFUL NOW!*

5. For the yellow, dump the entire yellow dye presolution and let the scarf soak for about 25 minutes with periodic agitation so that your fabric gets even contact with the dye. Remove from bucket and rinse THOROUGHLY.

*Repeat steps 1 - 4 for the orange and red dye. Be sure to completely rinse out the previous color from your bucket before starting the new one.

6. To get the nice gradient effect, only pour in about 1/3 or 1/4 of the orange dye presolution into the bucket and stir well. What this does is dilute the orange as you will see when you first go to dip it in.

7. *Note: the colors are about 1/3 each of the entire length, fold the scarf perfectly in half and hold the fringed side up with the other end to be dunked into the dye. Make a light mark where you want the gradient to begin, I used a pin [about 1/3 down from the fringe]

8. Dip the scarf to the farthest point you want the orange to start two or three times [take your time, don't rapidly dunk and yank it out LOL], afterwards dunk about 1 – 2” away from the last point you dunked, dipping about 2 or 3 times at the same spot. Proceed for a few more inches.

9. Lay out a large flat trash bag next to your bucket and CAREFULLY set the fabric on it making sure to keep the gradient end away from the lighter ends. Add another 1/3 or 1/4 of the dye presolution, stir, and continue from where you left off. Do not dunk from the very beginning of where you started!!!

10. Continue this process of adding the presolution in small parts while stirring and dip dyeing. Add the rest of the dye and finish the gradient.

11. Lay the scarf out on a trash bag to allow it to sit for about 25 minutes. Then rinse scarf out THOROUGHLY. **Avoid rinsing dye out near the yellow to avoid any staining

12. Repeat for the scarlet dye from the bold end of the orange.

13. To check if you have washed your dye out during post treatment, the water should run clear or nearly clear [and i mean VERY CLOSE to clear]. Once this is verified, wash it normally and there you go!



Labels: , , , ,